2.20. EXPERIMENTAL SETTINGS TAB
Overhang Wall
The overhang wall settings will allow one to set separate settings for just
wall overhangs. You can dene wall overhang angle and wall overhang
speed. Setting the angle to 90 degrees will prevent using this setting.
Enable Bridge Settings
Bridge settings is one of the most powerful and useful options within
experimental settings. A bridging move is when the extruder connects one
“post” to another “post”, with no material underneath to support this from
drooping due to gravity. When this setting is activated, you can control
how the extruder moves and cools in these sections only.
• Minimum Bridge Wall Length determines the minimum length of a
bridging move to use adjusted settings.
• Bridge Skin Support threshold determines if skin should use
bridging overrides. If skin is supported by less than X% it will use
bridge overrides.
• Bridge Wall Coasting determines what percentage of your coasting
value to use before entering a bridging move.
• Bridge Speeds will control how quickly your printer and extruder
are moving during dierent sections of the bridging moves. Faster
moves generally provide better bridge sections.
• Bridge Flow % determines what ow rate to use in dierent sections
of the bridge. A lower ow rate such as 90% helps provide cleaner
bridges.
• Bridge Density % determines how dense certain portions of the
bridging moves are. Values less than 100% may leave gaps between
the lines.
• Bridge Multiple Layers allows you dene the second and third
layer of a bridge individually. This can reduce time by speeding up
moves, as the rst layer of the bridge will support the next.
73
To Next Page
Loading...
