5.1. TROUBLESHOOTING
PROBE FAIL CLEAN NOZZLE
This means that the printer has detected a failed wiping routine and has not
been able to correct itself with 3 rewipe sequences. This is usually caused
by the wiping temps not being correct for the material that’s coating the
nozzle. Resolution:
• Use the correct Quickprint prole in Cura LulzBot Edition.
• If you’ve just switched from a material that is printed at a higher
temperature to one that prints at a lower temperature, try heating
the hot end to the wipe temperature recommended in that material’s
Quickprint prole.
A printed wiper pad handle can make this much easier:
http://devel.lulzbot.com/wiper_pads/wiper-pad-handle
HEATING FAILED
The hot end was not able to reach the target temperature.
83
To Next Page
Loading...
