ND30-09D 18 User's manual
Fig.13a. Screen 13 - visualization of the analog indicator
7.2 Parameters mode
This mode is used to determine the parameters of the meter. To enter
Parameters mode press the button for approx. 3 seconds and next
using the button or select Parameters mode, to accept press the
button . The parameters configuration mode is protected by a
password, if it was entered and it is different from zero. The password
prompt is skipped for the password 0000. If the password is incorrect, the
message "Wrong password. Read only menu" is displayed. Then it is
possible to view the parameters, but the changes are not possible.
Fig. 14. Screens while entering a password
If the password is correct or it has not been entered, you can set the values
according to Table 2.
Buttons are used to choose the parameter, to accept press the
button . Then use the buttons to choose the features of a
parameter or set the requested parameter values, i.e. you can choose the
digit in the decimal position by the button or the digit value by the
button or . The active position is signaled by the cursor. Set value
or parameter can be accepted by the button or canceled by pressing
Menu
OK
Select
Select
Cancel
To Next Page
Loading...
Need help?
General
