ND30-09D 2 User's manual
1 APPLICATION
The ND30 meter is a programmable digital instrument designed for the
measurement of 1-phase 2-wire and 3-phase 3 and 4-wire power network
parameters in balanced or unbalanced systems. The measured values are
displayed on a 3,5’’ TFT full-color screen, resolution: 320 x 240 pixel.
The meter enables control and optimization of the power electronic devices,
systems and industrial installations.
The meter provides measurement of: RMS of voltage and current, active,
reactive and apparent power, active, reactive and apparent energy, power
factors, frequency, the harmonics of current and voltage /up to 51st/, THD of
voltage and current, averaged active and apparent power P Demand,
S Demand, averaged current I Demand /15, 30 or 60 minutes/. Voltages and
currents are multiplied by given voltage and current ratios of the measuring
transformers. Power and energy indications take into account all
programmed ratio values. The value of each measured value can be
transmitted to the master system via the RS-485 or Ethernet interface.
Three relay outputs signal the overflow of the chosen value and
the programmable analog output maps the assigned parameter.
The temperature inputs can be used to control the temperature
of the transformers windings, motors.
There is a galvanic separation between following units of the meter:
- supply
- voltage inputs
- current inputs
- RS485 interface
- Ethernet interface
- alarm outputs
- analog output
- temperature input Pt100
2 METER SET
Complete set of the meter includes:
1. ND30 meter 1 pc
2. seal 1 pc
3. screw clamp to fix in the panel 4 pc
To Next Page
Loading...
Need help?
General
