ODK4 QUICK REFERENCE GUIDE
Luminator Technology Group
iii
SAFETY SUMMARY
The following are general safety precautions. They do not appear anywhere else
in this manual. They reflect practices that should always be applied.
KEEP AWAY FROM LIVE CIRCUITS
9 NOTE: Do not perform maintenance or service to equipment with the
power turned on. To avoid injury or possible damage to equipment always
remove all power.
9 NOTE: Discharge and ground a circuit before touching it.
9 NOTE: Observe all safety regulations.
DO NOT SERVICE OR ADJUST ALONE
Never reach into equipment with power applied. Always have someone present
who is capable of rendering aid.
CAUTION
ELECTROSTATIC SENSITIVE DEVICES.
ELECTROSTATIC CHARGE PREVENTION IS RECOMMENDED. USE
WRIST GROUNDING STRAP AND/OR ANTISTATIC GROUNDED
FLOOR MAT WHILE HANDLING ANY PRINTED WIRING ASSEMBLY
(PWA). PLACE PWA IN ANTISTATIC BAG FOR TRANSPORTING AND
STORING. SHOULD ANY PWA BE DETERMINED DEFECTIVE, REFER
IT TO ELECTRONICS BENCH SERVICE, OR RETURN IT TO
LUMINATOR FOR REPAIR AND OR REPLACEMENT
.
To Next Page
Loading...
General