MacDon FlexDraper FD135 - Installing Crop Dividers with Latch Option Onto Header; Removing Crop Dividers Without Latch Option from Header

214683 116 Revision A
Removing Crop Dividers without Latch Option from Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator’s manual for instructions.
4. Open or remove endshields. Refer to 3.2.3 Endshields, page 33.
1001841
A
B
Figure 3.137: Crop Divider
5. Remove bolt (A), lock washer, and flat washer.
6. Lower crop divider (B) and then lift to remove from
endsheet.
7. Close or install endshields. Refer to 3.2.3 Endshields,
page 33.
Installing Crop Dividers with Latch Option onto Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator’s manual for instructions.
4. Open or remove endshields. Refer to 3.2.3 Endshields, page 33.
OPERATION