214683 239 Revision A
Figure 3.408: John Deere S7 Display – Feeder
House Calibration
12. When calibration is complete, select SAVE to confirm
calibration.
Calibrating Header (John Deere S7 Series)
Feeder house calibration must be done before header calibration. If feeder house has not yet been calibrated, refer
to Calibrating Feeder House (John Deere S7 Series), page 236.
For best performance of auto header height control (AHHC), perform these procedures with header at steepest
angle. When setup and calibration are complete, adjust center-link back to desired header angle.
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator’s manual for updates.
1. Ensure center-link is set to D.
2. Rest header on down stops and unlock float.
3. Place wings in locked position.
Figure 3.409: John Deere S7 Display –
Harvesting Page
4. On the HARVESTING page, select the MENU icon (A)
in the bottom right corner of screen. The MENU opens.
OPERATION
To Next Page
Loading...
