MacDon FlexDraper FD135 - Page 241

214683 217 Revision A
1026086
A
Figure 3.351: John Deere Combine Display
9. Select HEADER (A) from the list of calibration options.
1003778
A
Figure 3.352: John Deere Combine Display
10. With HEADER selected, press icon (A). The icon will
turn green.
1003779
A
Figure 3.353: John Deere Combine Display
11. Click button (A) and instructions will appear on screen
to guide you through the remaining calibration steps.
NOTE:
If an error code appears during calibration, the sensor is
out of voltage range and will require adjustment. Refer
to Checking Voltage Range from the Combine Cab
(John Deere S and T Series), page 212.
NOTE:
If float was set heavier to complete the AHHC
calibration procedure, adjust to recommended
operating float after the calibration is complete.
OPERATION