214683 309 Revision A
Figure 4.3: Wide Configuration (Rear View)
A - 257 mm (10-1/8 in.) B - 257 mm (10-1/8 in.)
NOTE:
Dimensions are the same for both ends of the
auger. They should be within 15 mm (9/16 in.) of
the numbers given.
Wide configuration is an optional configuration for the
following combines:
• Challenger (670B/680B, 540C/560C, 540E/560E)
• CLAAS (590R/595R, 660/670, 760/770/780)
• John Deere (T670)
• Massey Ferguson (9895, 9540, 9560, 9545, 9565, 9380)
• New Holland CX (8X0, 80X0, 8.X0)
NOTE:
This configuration may increase combine capacity on wide
feeder house combines in certain crop conditions.
NOTE:
In some conditions, feeding may be further improved by
removing all bolt-on flighting. Refer to 4.1.7 Optional
Modification to Wide Configuration, page 322.
To convert to Wide configuration from Medium configuration, refer to 4.1.5 Converting from Medium
Configuration to Wide Configuration, page 318.
To convert to Wide configuration from Narrow or Ultra Narrow configuration , refer to 4.1.6 Converting from
Ultra Narrow or Narrow Configuration to Wide Configuration, page 320.
Figure 4.4: Ultra Narrow Configuration
(Rear View)
A - 760 mm (29-15/16 in.) B - 602 mm (23-11/16 in.)
NOTE:
Dimensions are the same for both ends of the
auger. They should be within 15 mm (9/16 in.) of
the numbers given.
Ultra Narrow configuration is an optional configuration
that may improve feeding performance on combines with
narrow feeder houses. It may also be helpful when
harvesting rice.
HEADER ATTACHMENT/DETACHMENT
To Next Page
Loading...
