Mackie THUMP210XT - Heat Level; Rotate; Bluetooth; Pair

THUMP210XT 10" 1400W ENHANCED COMPACT POWERED LOUDSPEAKER
4
E. Heat Level
If the temperature is the aforementioned “frigid”, we’re pretty confident that you’re going to want to crank the heat... perhaps
not, but we’d bet on it!
This works similarly to that of the fan speed with settings ranging from  (low heat) to 5 (cranked heat). Quickly press
this button to what setting you would like, up to five times. The LED will flash green the number of the current setting.
F. Rotate
Last, but absolutely not least... the fan AND heater are both rotatable (although the one switch controls whichever one
is engaged, of course).
The rotation speed may be set to  (low), 2 (medium), or 3 (high). As with the fan speed and heat level, quickly press this button
to what setting you would like, up to three times. The LED will flash green the number of the current setting.
Please note that the rotation function only works when the loudspeaker is mounted on the T00 tripod
or SPM400 pole mount. Operators are standing by!
Bluetooth / Pair
While not a “physical” connection, stereo channel 3/4 is considered the Bluetooth channel and its volume is raised
and lowered via the device.
This is how to connect your device to the ThumpXT via Bluetooth! Read on...
Upon powering up the ThumpXT, the Bluetooth function is either:
() In sleep mode. See ‘Pairing and connecting for the first time’ (below) or...
(2) ...Paired and connected. See ‘Previously paired and connected devices’ (also below).
Pairing and connecting for the first time:
To enter pairing mode, press and hold the pair switch down for at least three seconds. The LED will illuminate
and slow flash blue for approximately 30 seconds while in pairing mode. [The LED will continue to flash until
it has successfully paired and connected].
While ThumpXT is in pairing mode, simultaneously scan for Bluetooth devices on your device. You should see ThumpXT appear
in the list of “available devices”. Select it by tapping it. From there, your Bluetooth device should indicate that it is successfully
connected. Additionally, the pair button will stop flashing and remain solid blue. If it does not, start the pairing process again,
and make sure that ThumpXT and your device are both in pairing mode at the same time.
Previously paired and connected devices:
The Bluetooth connection will disconnect if it’s out of range or if ThumpXT is powered o. Previously paired and connected
devices will automatically reconnect (unless turned o via the Thump Connect 2 App) and the pair button will once again
illuminate a brilliant blue.
To drop the device from being paired with the ThumpXT, press and hold the ‘Bluetooth Pair’ button down
for at least three seconds.