THUMP210XT 10" 1400W ENHANCED COMPACT POWERED LOUDSPEAKER
22
Rigging Hardware and Accessories
Rigging our loudspeakers will invariably require hardware not supplied by us. Various types of load-rated hardware
are available from a variety of third-party sources. There are a number of such companies specializing in manufacturing
hardware for designing and installing rigging systems. Each one of these tasks is a discipline in its own right.
Because of the hazardous nature of rigging work and the potential liability, engage companies that specialize
in these disciplines to do the work required.
We do oer certain accessory rigging items and some of them may be used with a variety of products.
While these accessories are intended to facilitate installation, the wide variety of possible installation conditions
and array configurations do not permit us to determine their suitability or load rating for any particular application.
We are not in the business of providing complete rigging systems, either as designers, manufacturers, or installers.
It is the responsibility of the installer to provide a properly engineered, load-certified rigging system for supporting
the loudspeaker from structure.
ThumpXT loudspeakers may be individually flown using a PA-A3 Eyebolt Kit, part number 2036960.
Rigging Notes
The ThumpXT loudspeaker’s integral mounting points are designed to support only the weight of their own loudspeaker
with suitable, external hardware. This means that each ThumpXT loudspeaker must be supported independently
of any other ThumpXT loudspeaker and any other loads. At least the top two rigging points must be used to hang
each ThumpXT loudspeaker. The rear / bottom one helps with an even vertical hang or pullback for a down-tilt angle.
Thump20XT Fly Points
MP = Mounting Point
MUSIC
MON
LIVE
CLUB
MIN MIN
SIG/OL
MPMPMP
To Next Page
Loading...
