THUMP210XT 10" 1400W ENHANCED COMPACT POWERED LOUDSPEAKER
9
Chapter 4 : Placement
Introduction
WARNING: Installation should only be done by an experienced technician. Improper installation may result
in damage to the equipment, injury or death. Make sure that the loudspeaker is installed in a stable and secure
way in order to avoid any conditions that may be dangerous for persons or structures.
ThumpXT loudspeakers are designed to sit on the floor or stage as the main PA or as monitors. They may also be pole-mounted
via the built-in socket on the bottom of the cabinet. Be sure the pole is capable of supporting the weight of the loudspeaker.
The T00 is a great tripod option and the SPM400 is a nice choice when using a subwoofer.
These loudspeakers may also be flown via their integrated fly points as detailed on the following pages.
Be sure to read the PA-A3 Eyebolt Installation Instructions, as well.
NEVER attempt to suspend a Thump loudspeaker by its handles.
Check to make sure that the support surface (e.g. floor, etc.) has the necessary mechanical characteristics to support
the weight of the loudspeaker(s).
When pole-mounting loudspeakers, be sure that they are stabilized and secured from falling over or being accidentally
pushed over. Failure to follow these precautions may result in damage to the equipment, personal injury, or death.
Thump loudspeakers may be laid out horizontally as monitors for the band at a 40˚ angle (as seen below). It is intended
to be used only when the speaker is in its wedge configuration and works best when on a hard work surface, like a stage.
As seen above, the Running Man logo is rotatable for when the loudspeaker is used as a monitor!
To Next Page
Loading...
