Magnescale LT30 Series - Commands

38 (E)
LT20A / LT30 Series
Command
∗P-P
∗MAX
∗MIN
∗REAL
∗RCL
∗RES
∗START
∗P= ¥ ¥ ¥ ¥ ¥ ¥ ¥/∗P=?
∗CH= ¥ ¥ ¥ ¥ ¥ ¥ ¥/∗CH=?
∗CL= ¥ ¥ ¥ ¥ ¥ ¥ ¥/∗CL=?
∗r
R
KEYON
KEYOFF
∗PAUON
∗PAUOFF
∗LCHON
∗LCHOFF
∗L
∗LO=?
VER=?
Operation
Switch to peak-to-peak value mode.
Switch to maximum value mode.
Switch to minimum value mode.
Switch to current value mode.
Recall the preset value.
Reset.
Start.
Set/read preset value.
Set/read comparator upper limit.
Set/read comparator lower limit.
Request for output for one channel.
Request for outputs for 2 channels.
Allow use of front panel key.
Prohibit use of front panel key.
Stop peak value update
Release peak value update stop
Latch the current value.
Release the current value latch
Reset reference point
Read reference point offset value
Read software version
9-6. Commands
1. Command table (Converted to ASCII code)
∗ : For the 1 channel model or the 2 channel model A
channel use “A”, for the 2 channel model B channel
use “B”.
¥ : Value to be set. (Example: 12.3456)