61
Control unit MGCplus
Description of menus and parameters
6.5 Menu "System"
Operational view > Main menu > System
Parameter Description
Reboot Reboot the control unit.
A reboot may be required after parameter changes.
› Yes
› No
Factory setting
› No
Language
Changing menu language. ä Page 29, chapter 5.1.
Control unit Shows information about the hardware (Hardware info) and the firmware.
IP settings The parameter "Change IP method" allows you to choose between static IP
or DHCP. A change is only required for remote support or advanced applica-
tions.
Additionally, this menu shows the current IP settings: Method, address,
mask, gateway and MAC.
Remote support Select option for remote access / remote support.
Prerequisites
The requirement for remote access / remote support are as follows:
› The control unit is connected via LAN.
› Internet access is available.
› All IP settings are configured correctly.
Via Magnetic, you can purchase additional hardware to connect the control
unit to the Internet without connecting it to your LAN.
Options
› No remote support: The control unit does not send support information
to Magnetic. The remote access is deactivated.
› Send emails only: The control unit does not mail any application protocols
to Magnetic.
› Remote access only: The control unit establishes an SSH tunnel (Secure
Shell) to Magnetic, enabling remote access for technical support.
› Full remote access: Activates all available remote support functions.
Factory setting
› No remote support
USB drive For advanced logging and troubleshooting purposes, you can connect a USB
stick to the control unit.
This menu shows the status, the label and the free capacity. Additionally, you
can remove the USB stick safely.
CAN bus Shows information about the internal system bus.
Restore settings
ä Page 62, chapter 6.5.1.
Table 38: System
To Next Page
Loading...