Martin MAC One - Page 31

Martin
®
MAC One User Manual Rev. B 31
SPEED
PAN/TILT
STANDARD
Adjust speed of pan and tilt movement
SMOOTH
FAST
EFFECT
FOLLOW P/T
Effects speed follows pan/tilt speed
setting
STANDARD
Adjust speed of effects movement
SMOOTH
FAST
DIMMER CURVE
LINEAR
Optically linear dimming curve
SQUARE LAW
Square law dimming curve
INV SQ LAW
Inverse square law dimming curve
S-CURVE
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming
curve)
TUNGSTEN
EMULATOR
OFF
Color temperature and dimming
characteristics emulate incandescent
tungsten lamp behavior
ON
COLOR MODE
EXTENDED COLOR
Color mixing optimized for saturation
CALIBRATED
Color mixing optimized for even color
rendition across multiple fixtures
VIDEO TRACKING
ENABLED
Color fading optimized for speed of
color changes
DISABLED
Color fading optimized for smoothness
DMX RESET
ON
Fixture can be reset via DMX
OFF
Fixture cannot be reset via DMX
EFFECT
SHORTCUT
ON
Effects take shortest route during
changes, crossing open positions if
necessary
OFF
Effects avoid open positions during
effects changes
COOLING MODE
CONSTANT FAN FULL
Fans optimized for maximum light
intensity, fans run at full speed, light
intensity reduced if necessary to keep
fixture within temperature limits
CONSTANT FAN MEDIUM
Fans run at medium speed, light
intensity reduced if necessary to keep
fixture within temperature limits
CONSTANT FAN LOW
Fans run at low speed, light intensity
reduced if necessary to keep fixture
within temperature limits
CONSTANT FAN ULOW
Fans optimized for lowest noise, fans
run at ultra-low speed, light intensity
reduced if necessary to keep fixture
within temperature limits
REGULATE FANS
Compromise between light intensity and
quietness, fan speed temperature-
regulated, light intensity only reduced if
fans reach full speed and further action
necessary to keep fixture within
temperature limits