Martin MAC One - Page 32

32 Martin
®
MAC One User Manual Rev. B
DISPLAY
DISPLAY SLEEP
10 MINUTES
Control panel display goes into sleep
mode 10 minutes after last key press
5 MINUTES
Control panel display goes into sleep
mode 5 minutes after last key press
2 MINUTES
Control panel display goes into sleep
mode 2 minutes after last key press
ON
Control panel permanently on
DISPLAY INTENSITY
1 … 100%
Set control panel display intensity in %
(default = 50%)
DISPLAY ROTATION
NORMAL
Control panel display orientation normal
ROTATE 180
Control panel display inverted
DISPLAY CONTRAST
3 … 100%
Set control panel display contrast
(default = 50)
ERROR MODE
NORMAL
Enable error messages and warnings in
control panel display
SILENT
Disable error messages and warnings
in display (the status LED will still light
to indicate fixture status if an error has
been detected or the fixture has a
warning)
HIBERNATION
MODE
ON
Enable Hibernation Mode (light output
set to zero, all effect movement
disabled)
OFF
Disable Hibernation Mode
SCENE CAPTURE
RECORD
SAVE
Saves all current DMX values as
playback scene
PLAYBACK
ENABLE
Sets fixture to run currently saved
playback scene after power cycle /
reset. Any new DMX input disables
scene playback until next power cycle.
DISABLE
Disable scene playback functionality
BACKLIGHT IN
COMPACT
ENABLE
Disabling allows Backlight pixels to be
OFF in Compact DMX Mode, or allows
Backlight pixels to follow Beam LED
DISABLE
DEFAULT SETTINGS
FACTORY
DEFAULT
LOAD
ARE YOU SURE?
→ YES/NO
Return all settings (except calibrations)
to factory defaults
CUSTOM 1
LOAD
ARE YOU SURE?
→ YES/NO
Load Custom Settings 1
SAVE
ARE YOU SURE?
→ YES/NO
Save current settings as Custom
Settings 1
CUSTOM 2
LOAD
ARE YOU SURE?
→ YES/NO
Load Custom Settings 2
SAVE
ARE YOU SURE?
→ YES/NO
Save current settings as Custom
Settings 2
CUSTOM 3
LOAD
ARE YOU SURE?
→ YES/NO
Load Custom Settings 3
SAVE
ARE YOU SURE?
→ YES/NO
Save current settings as Custom
Settings 3