© Martin Engineering GmbH 8 M3727UK-09/15
Introduction
2.2.2 Restrictions on the use of the product
The product specified here may only be used within the scope of the
specifications referred to above. Usage in a higher equipment
protection category or under other operating conditions than those
specified by Martin Engineering shall be deemed misuse and is only
permitted if approved by Martin Engineering.
Operation of this product is only permitted if all parts are in a flawless
state. Shut down this product immediately in cases of damage
(cracks, rust, etc...), changes, or other mechanical modifications.
Martin Engineering or one of its representatives can assist you with
the product configuration if you need to use this product for
a different purpose.
2.3 Occupational safety
2.3.1 Safety information, occupational safety
These installation instructions must be read through in their entirety
before work may be started on the product or on the conveyor
system supplied by the customer.
The owner-operator must ensure that all installation, inspection and
maintenance work is performed solely by trained specialists.
Work on conveyor systems and their accessories must always be
performed during shut-down. The procedures described in the
applicable installation instructions for shutting down the conveyor
system must always be complied with.
All of the safety devices and safeguards must be reattached and/or
made operational immediately following completion of the work.
The installation must be carried out to completion before the system
is started up. The flawless execution of all operating steps must be
tested before the conveyor system can be started up again. Please
observe all information on the installation and start-up of the
product.
To Next Page
Loading...