© Martin Engineering GmbH 21 M3727UK-09/15
Installation
5.2 Installation of the MARTIN
®
TORNADO air cannon
The air cannon can only be installed and/or operated in connection
with a nozzle and flange bracket. Additional add-ons can optionally
be installed. The various components are installed consecutively in
each case.
Parts of this installation are described in these installation
instructions.
The remaining steps are described in the installation instructions for
the nozzles and flange brackets and for the optional components. All
of the installation steps are listed in the following table. Each step
indicates where the corresponding information can be found:
5.2.1 Installing the nozzles
Follow the instructions for this in the installation instructions for the
flange brackets and nozzles.
5.2.2 Installing the flange bracket
Follow the instructions for this in the installation instructions for the
flange brackets and nozzles.
No. Installation step Instructions
1 Installing the nozzles M3773
2 Installing the flange bracket M3773
3 Installing the safety slide (optional) M3727
4
Installing the Martin
®
Blast Guard (optional)
M3903
5 Installing the air cannon M3727
6 Installing the air surge limiter (optional) M3797
7 Installing the thermal hood (optional) M3964
8 Connecting the air cannon to the
compressed air supply
M3727
Tab. 1: Installation steps
NOTE
Since the placement and installation of the flange brackets and
nozzles always depend on the project, the detailed positioning of
the nozzles must be described in a separately prepared project
documentation.
To Next Page
Loading...