© Martin Engineering GmbH 20 M3727UK-09/15
Installation
5 Installation
5.1 Safety information
WARNING! RISK OF EXPLOSION!
Increased risk when using a cutting torch or welding device in
closed rooms!
Check the gas and dust content of the air before usage.
WARNING! RISK OF EXPLOSION
Flying sparks or mechanical stresses can cause the air cannon
tank to explode.
Never weld the air cannon tank and never expose it to mechanical
loads such as clamping or mechanical stresses.
Bleed the air cannons before every type of installation and
maintenance work.
DANGER! MATERIAL FLYING ABOUT!
Firing the air cannon can cause material to be slung around which
can lead to fatal injuries.
Do not open any access ports to the container and to not enter it
for as long as the air cannons are filled and operating.
Clear out the safety zone before firing if the air cannons are
installed in an open container.
WARNING!
If there is an excess pressure of more than 0.28 bar in the
bulkcontainer, then suitable measures must be taken to prevent
materials or media from the bulk container from penetrating the air
cannon. This would contaminate the valve and the tank and impair
the functional reliability of the air cannon.
WARNING! RISK OF EXPLOSION!
The air cannon tank can burst if the permissible operating
pressure is exceeded.
Refer to the safety valve documentation for further information.
Never use a safety valve with a pressure limit higher than the air
cannon tank's allowable operating pressure or with an exhaust
output lower than that of the air cannon.
To Next Page
Loading...