Martin Wizard - Installation; Wall Mounting

10 Wizard user manual
I NSTALLATION 3
The Wizard can be hung overhead with a clamp (not included), mounted
vertically on a wall, or placed on the floor (using the optional floor stand).
Warning! Block access below the work area before proceeding. Always
use a secure means of secondary attachment.
WALL MOUNTING
To mount the Wizard on a wall, or other vertical surface:
1 Verify that the surface is capable of bearing the weight of the fixture.
2 Set two 8mm-diameter hex bolts or screws, 155 mm (6.1 in.) apart (center to
center), in the mounting surface.
3 Set an eye bolt in the mounting surface for the
safety cable.
4 Fold the mounting bracket so that it lies flat
against the back of the fixture and tighten the
swivel locks. We recommend that you remove
the swivel locks and replace them with M8
hexagonal lock nuts (2 x P/N 08132701);
alternatively set the swivel locks so that they lie
flat against fixture.
5 Hang the fixture on the wall over the two
screw/bolt heads using the two slotted holes in the mounting bracket.
6 Install a safety cable that can hold at least 10 times the weight of the fixture through
the safety cable eye on the fixture and attach this to the eye bolt.
7 Verify that the fixture is at least 0.1 meters (4 in.) from the surface to be illuminated
and at least 0.3 meters (12 in.) from any combustible materials. Verify that the
clearance around the air vents is at least 0.1 meters (4 in.).
max 13mm / ½"
Ø8mm