Installation 11
OVERHEAD MOUNTING
To hang the Wizard on an overhead support:
1 Verify that the structure can support at least 10 times the weight of all installed
fixtures, clamps, cables, auxiliary equipment, and other items.
2 If hanging the fixture with a rigging clamp, verify that the clamp is undamaged and
is designed for the fixture’s weight. Bolt the clamp securely to the bracket with a
grade 8.8 (minimum) M12 bolt and lock nut, or as recommended by the clamp
manufacturer, through the clamp hole in the mounting bracket.
3 If permanently installing the fixture, verify that the hardware (not included) and
mounting surface can bear at least 10 times the fixture’s weight. Any of the six
13mm (½ in.) holes in the mounting bracket may be used for attachment, but
ensure that the load is distributed evenly.
4 Working from a stable platform, clamp or fasten the fixture to the structure.
5 Install a safety cable that can hold at
least 10 times the weight of the fixture
through the safety cable eye on the
fixture.
6 Loosen the swivel locks, tilt the fixture to
the desired angle, and retighten.
7 Verify that the fixture is at least 0.1
meters (4 in.) from the surface to be
illuminated and at least 0.3 meters (12
in.) from any combustible materials.
Verify that the clearance around the air
vents is at least 0.1 meters (4 in.).
To Next Page
Loading...
