Martin Wizard - DMX Operation; DMX Modes; 1-channel DMX Operation

DMX operation 19
DMX OPERATION 7
The Wizard can be connected to and operated from a DMX controller. To do this
you need to:
1 Choose and set one of the three DMX modes. The three modes are described in
the following section, “DMX modes”.
2 Set a DMX control address. This is described in “DMX control address” on page 21.
DMX MODES
The Wizard has three DMX modes to choose from:
• 1-channel mode provides control of the built-in stand-alone features.
• 6-channel mode provides position control of all effects. This is the default factory
set mode.
• 8-channel mode provides position control of all effects, plus control of the mirror
drum swivel rate, and the color and gobo wheel change speed.
1-channel DMX operation
The functions shown in the following table are available in 1-channel mode.
When a “stand-alone” function is selected, the fixture steps through a routine
using a built-in microphone to trigger the action to the beat of the music. Note
that multiple fixtures cannot be synchronized in this mode.
DMX value Percent Function
0-10
11-20
21-80
81-115
116-140
141-175
176-210
211-255
0-3
4-7
8-31
32-44
45-54
55-68
69-82
83-100
Light off
Light on
Strobe
Slow music trig (every 2 seconds)
Medium music trig (every second)
Fast music trig (every 0.2 seconds)
Random music trig (between 0.2-2.0 seconds)
Trigger whenever DMX value 240 is crossed