Martin Wizard - Operation from the Floor

12 Wizard user manual
OPERATION FROM THE FLOOR
To operate the Wizard from the floor you need the optional floor stand (P/N:
91606008).
1 Attach the floor stand to the mounting bracket. The floor stand is longer at one
end. Install the stand so that the long end is positioned where the load is greatest.
This will depend on the angle that the Wizard is set at.
2 Set the fixture on the floor. Adjust the mounting bracket and tighten both swivel
locks.
3 Verify that the fixture is stable, that it is at least 0.1 meters (4 in.) from the surface to
be illuminated and at least 0.3 meters (12 in.) from any combustible materials.
Verify that the clearance around the air vents is at least 0.1 meters (4 in.).
The stand is designed for use on a flat surface. It is not intended to be used in any
other way.