28 Wizard user manual
REQUIREMENTS
The following are required in order to install software.
• The Wizard update file, available for download from the User Support Area of the
Martin web site (http://www.martin.dk).
• The Martin Software Uploader program, version 4.0 or later, available for
download from the User Support Area of the Martin web site.
• A Martin MP-2 Uploader connected to a Windows 95/98/ME/2000 PC, or a
LightJockey Controller with DMX Interface card.
Updating fixture firmware with the MP-2 Uploader
1 Connect a prepared MP-2 Uploader to the DMX link. Apply power to the fixtures
and the MP-2. Wait a few moments for the fixtures to reset.
2 Select
Read Memory Card from the MP-2 main menu.
3 Use the buttons on the right to scroll through the card slots. Select the slot that
holds the desired version of the Wizard firmware.
4 Select
Update Software. Select Yes to confirm.
5 Select
Update in DMX mode to start the upload. The MP-2 initializes all
connected Wizards, which respond with two yellow LEDs in the status display.
Avoid interrupting the process: this will corrupt the software.
6 After a successful upload the fixtures reset with the new software. If an error occurs
and the fixtures do not reset, data was interrupted or corrupted during transmission.
To Next Page
Loading...
