MARV User Manual
2
Contents
Using Safe Mode 22
How to turn off [Safe Mode] at the
machine
How to turn [Safe Mode] OFF → ON
at the machine
Handling an Object after Printing 23
Removing the object from the
print bed
Removing the raft and support
structures (if necessary)
Using the MARV Software 24
Main screen
Editing functions
Settings
MARV Maintenance 29
Replacing a Filament 29
Replacing the Filament
while Printing 30
Calibrating the Nozzle 31
Cleaning the machine 32
Cleaning the Nozzle 32
Cleaning method 1: Cleaning the
nozzle via a computer software.
Cleaning method 2: Cleaning the
nozzle without a computer software.
Updating the Firmware 34
Specications 37
Troubleshooting 38
The Machine Does Not Turn On 38
The Software Will Not Install 38
A File Cannot Be Located after
an SD Card Is Inserted 39
Files Will Not Print 40
The Printer Is Not Working 40
Printing Quality Is Not Satisfactory 41
The Filament Does Not
Extrude During Printing 44
The Printed Object Cannot Be
Removed from the Print Bed 44
How to use the manual 3
Symbols used in the manual 3
Legal Notices 4
Model Names 4
Disclaimers 4
Copyright 4
Trademarks 4
FCC (Federal Communications
Commission) 5
FCC WARNING 5
AC Adapter 6
Important safety instructions 7
Supplied Accessories 8
Machine and Installation
Information 9
Installation Space 9
Names of parts 10
Exterior
Interior
Removing the Packing Materials 12
Installing the Software and
Connecting the USB Cable 13
Basic Operation 14
Filament Installation 14
Print Bed Preparation 18
Connecting Power 19
Printing from the Computer 20
Printing from the SD Card 21
Canceling Printing 22
To Next Page
Loading...