Marv MW10EU1 - Printing Operations; Printing from Computer

MARV User Manual
20
Printing from the Computer
Print settings can be changed using the MARV software installed on the computer.
For more information about the functions of the MARV software, refer to 'Using the
MARV Software' on P.24.
Caution
If the computer enters Sleep Mode during printing, printing stops. If a print job stops, it cannot
resume. Sleep Mode should be turned off or adjusted before printing an object. It is recommended
that Sleep Mode on the computer be disabled before running the MARV software.
1.
Click [Open] in the software window.
2.
Click .stl le to print.
3.
To edit the le click [Edit].
For more information about the [Edit] menu, refer to 'Editing functions' on P.26.
4.
Click [Save].
Select an extension, enter a lename, and save the le. (If you print from the
machine using an SD card, select the .marv extension.)
5.
Click [Settings] to designate the output settings.
For more information about the [Settings] menu, refer to 'Settings' on P.27.
6.
Click [Print].
When the nozzle is heated, printing begins. (nozzle preheating time:
approximately 3 minutes)
Note
When an object is printed, the nozzle moves to the edge of the print bed and discharges a small
quantity of lament and then continues printing. When the object is printed, remove the object
and the discharged lament.