MARV User Manual
23
Handling an Object after Printing
Removing the object from the print bed
When the print bed and the staging brackets lower and [MARV is Ready] is displayed
on the LCD screen, put on gloves and remove the product from the print bed. Remove
the object from the print bed.
Caution
• Do not touch the nozzle during printing and after printing has been canceled. The nozzle becomes
hot during printing and remains hot for a period after it stops. To avoid burns, ensure that you wear
gloves.
• When you remove the printed object from the print bed, wear gloves to prevent hand injuries from
any sharp edges on the object.
Removing the raft and support structures (if necessary)
If you use a raft or other structure to support the object during printing, remove them
from the printed object when you separate it from the print bed. Wear gloves when
removing supports from the object to protect your hands from sharp edges. Use tools
to remove the supports, such as tweezers and nippers.
To Next Page
Loading...