Marv MW10EU1 - Replacing the Filament While Printing

MARV User Manual
30
Replacing the Filament while Printing
If a lament runs out of lament while printing, replace it with a new one after pressing
[Pause ] on the display. (Allowed time before resuming: 10 minutes)
Note
• If you select Pause, the surface of the printing output may be uneven.
• Be sure to use [Pause] only when needed, such as when changing the lament becomes
necessary.
• To prevent a machine malfunction, printing will be canceled if it is not resumed within 10 minutes.
• Pause is available only for printing objects with height of 135 mm or less.
• While the printing is paused, do not touch or move the object on the stage.
• [Load] and [Unload] cannot be used when printing is paused. Remove the lament from the nozzle
and insert the material manually.
1.
From the MARV software, press [Pause ].
Printing will stop and the stage will lower.
2.
Remove the lament from the nozzle. Press [Pause ] and remove the
lament immediately.
Note
• After you select Pause, remove the lament before the nozzle cools down.
• [Load] and [Unload] cannot be used when printing is paused. Remove the lament from the
nozzle and insert the material manually.
3.
Replace the lament with a new one.
4.
Insert the lament into the nozzle unit.
5.
Press [Resume ] to resume printing.