Marv MW10EU1 - Important Safety Instructions

MARV User Manual
7
Important safety instructions
Please read this entire section before using the machine. These instructions are
intended to prevent any potential damage to the machine and injury to the user
or others. Failure to adhere to these instructions may result in injury to the user or
others, or may cause damage to the machine or operation errors.
• Do not install the machine on an unstable surface, such as an unstable shelf or uneven
oor.
• Do not damage the power cord or any cables.
• Be sure to use the designated voltage only.
• Use manufacturer-supplied components and accessories only. We are not liable for
performance degradation, breakdowns, or accidents caused by third-party products.
• Using manufacturer-supplied laments is recommended for achieving the best printing
quality. Using third-party laments may result in unsatisfactory printing quality and a
blocked nozzle, and prevent the device from printing at full capacity.
• For the best printing results, allow the nozzle to cool down before printing.
• Do not shake or cause physical impacts to the machine.
• Do not disassemble or modify the machine.
• Be sure to turn off the power and disconnect the power cord and cables when moving
the machine.
• Do not turn off the power or load or remove the lament during printing.
• Do not turn off the software or open machine covers during printing. It can interrupt
printing or cause a system failure.
• Do not touch the nozzle during installation, operation, or immediately after the operation
is complete. Doing so may cause burns.
• Do not forcefully move or cause physical impacts to the nozzle unit. It may cause the
machine to malfunction or damage the sensors.
• Calibrate the gap between the print bed and the nozzle before printing.
• Do not insert or drop objects inside the printer (lament, etc.). Doing so may cause re
or damage.
• After use, open laments should be sealed and kept in a dry environment and out of
direct sunlight.
• Be sure there is adequate lament on the lament before printing.
• When printing stops due to a shortage of lament, replace the lament. If a printing job
is discontinued, it cannot be resumed. Before using the machine, check that there is
enough material available on the lament.