MARV User Manual
5
FCC (Federal Communications Commission)
MARV: MW10U1, MW10U2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
FCC WARNING
Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of the FCC
Rules. Do not make any changes or modi cations to the equipment unless otherwise speci
ed in this manual. If you make such changes or modi cations, you could be required to stop
operation of the equipment.
CANON KOREA BUSINESS SOLUTIONS INC.
607, Teheran-ro, Gangnam-gu, Seoul, Korea
TEL No.1588-2500
Note
• This equipment complies with the Canadian ICES-003 Class B limits.
• Respecte les limites de la classe B de la NMB-003 du Canada.