MARV User Manual
43
Was the position and orientation of the printed object correct?
The printed object can be affected by unstable or uneven placement. For
enhanced printing results, rotate the model in the le before you import it so that
the largest or attest surface is the bottom side of the printed object.
"Is the size or the surface thickness of the model less than 2mm?"
For enhanced printing results, the surface thickness must be at least 2 mm.
Ensure that the object's surfaces are at least 2 mm thick before printing it.
How do I print my object if the bottom side can't support the object while it
is printing?
For enhanced printing results, the bottom side of the object must be stable on
the print bed. Edit the object's model to enlarge the bottom side or add a support
structure.
Do I have to use manufacturer supplied laments?
Using third-party laments may reduce printing quality and block the nozzle. For
enhanced printing results and to prevent machine breakdown, It is recommended
to use manufacturer supplied laments. The machine's warranty does not cover
breakdowns that are caused by using third-party laments.
When should I replace the lament?
Always replace a lament with a new one. The performance of a lament
deteriorates if it is left open for extended periods. An open lament should be used
as soon as possible.
How does moisture affect the lament?
If moisture enters the lament, it may affect the way that the lament extrudes from
the nozzle and affect the quality if the printed object. When you notice lament
extrusion and print quality issues, replace the lament. If you open a lament and
don't use it immediately, seal it and then store it in a cool, dark, and dry location.
The color of the printed object is not what I expected.
When a lament is replaced, the nozzle may contain lament residue of a different
color. The new color can be contaminated by the residual color. To avoid color
contamination when you change the lament, remove the lament residue from
the nozzle using the supplied nozzle maintenance pin. To prevent burns, wear
gloves when you clean the machine and replace the lament.
Does the color of the printed object vary?
When a lament is replaced, the nozzle may contain lament residue of a different
color. The new color can be contaminated by the residual color. To avoid color
contamination when you change the lament, remove the lament residue from
the nozzle using the supplied nozzle maintenance pin. To prevent burns, wear
gloves when you clean the machine and replace the lament.
To Next Page