Maschio FIORE - REMOVING; Removing sickle bar mower

REMOVING
15
cod. G19503950
3
CAUTION: Before you work around hitch:
 6723HQJLQH
 /2&.SDUNEUDNH
 ),50/<EORFNPRZHURQKRUL]RQWDOVXUIDFH
H
D
E
I
F
J
G
Fig. 16
Fig. 17
B
A
C
Fig. 15
Removing sickle bar mower
7KHVLFNOHEDUPXVWEHVHWXSRQÀDWDQGFRPSDFWJURXQG
supported by the relative supports (A and B, Fig. 15).
1. Raise sickle bar.
2. Put parking stand (A and B, Fig. 15) in the DOWN
position: install spring locking pin in order to secure
parking stand (C, Fig. 15).
3. Lower sickle bar to the ground.
4. Unhook the PTO schaft (, Fig. 16) from the tractor
and put in on the special hook.
5. Remove quik-lock pin (D, Fig. 17) and pin (E, Fig. 17)
from center link (F, Fig. 17).
NOTE: Put quik-lock pins and pins back into brackets
on sickle bar for storage.
6. Remove draft links (J, Fig. 17) from draft link brackets
(G, Fig. 17) by removing quiklock pins (H, Fig. 17) and
pins (I, Fig. 17).
NOTE: Put quik-lock pins and pins back into brackets
on sickle bar for storage.
7. Drive tractor forward slowly.