EasyManua.ls Logo

Maschio FIORE - SERVICE; Cleaning and oiling the sickle bar; Storage

Default Icon
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE
35
cod. G19503950
3
Cleaning and oiling the sickle bar
DANGER
Cleaning and oiling are very dangerous operations.
Always comply with the following instructions:
 /LIWWKHLPSOHPHQWE\PHDQVRIWKHOLIWOLQNVLQDÀDWSODFH
where it cannot slip;
 2SHUDWH WKH PRZLQJ EDU FKHFNLQJ WKDW WKHUH DUH QR
persons or animals in the vicinity;
 %UDNHWKHWUDFWRUDQGPDNHVXUHLWLVXQDEOHWRPRYH
 Wash the sickle bar with a jet of pressurized water,
standing at least one and a half meters away from
the implement;
 6ZLWFKRIIWKHWUDFWRUUHPRYHWKHVWDUWHUNH\DQGGLVHQ-
gage the pto;
 &KHFNWKHFRQGLWLRQRIWKHFXWWHUV
 When the mowing bar is dry, lubricate the cutting
blades with very viscous oil;
 2SHUDWHWKHVLFNOHEDUIRUDIHZVHFRQGVFKHFNLQJWKDW
there are no persons or animals in the vicinity;
 6ZLWFKRIIWKHWUDFWRUUHPRYHWKHVWDUWHUNH\DQGGLVHQ-
gage the pto;
 )LWWKHJXDUGVRYHUWKHFXWWHUVDQGRXWHUVNLG&)LJ
61).
IMPORTANT! The cutting blades must be cleaned and
lubricated every day after work.
Storage
It is advisable to proceed in the following way at the end
of the season or if the machine is to remain inactive for a
long period of time:
 7UHDWWKHLPSOHPHQWLQFRPSOLDQFHZLWKWKHLQVWUXFWLRQV
given in the chapter entitled: “Cleaning and oiling the
cutters”.
 &DUHIXOO\ FKHFN IRU DQ\ GDPDJHG RU ZRUQ SDUWV DQG
replace these as necessary.
 )XOO\WRUTXHDOOVFUHZVDQGEROWV
 $SSO\DOLWWOHOXEULFDQWWRWKHXQSDLQWHGSDUWV
 3URWHFWWKHHQWLUHLPSOHPHQWZLWKDFRYHU
 /DVWO\VWRUHWKHLPSOHPHQWLQDGU\SODFHZKHUHLWFDQQRW
be tampered with by unauthorized persons; the mowing
PDFKLQHPXVW EHVHWXSRQ ÀDWDQGFRPSDFW JURXQG
supported by the relative supports (H and I, Fig. 62).
Careful compliance with these instructions will be all
to the advantage of the user who will be sure to use an
implement in perfect conditions when work begins again.
Fig. 62
Fig. 61
H
I
C

Table of Contents

Related product manuals