Maschio FIORE - SERVICE; Replacement of section-holding bar (riveted); Replacement of sections (riveted); Replacement of bar holding removable tooth

SERVICE
39
cod. G19503950
3
Fig. 73
Fig. 72
Replacement of tooth-holding bar (riveted) (G Fig. 71)
:LWKWKHLPSOHPHQWUHVWLQJRQWKHJURXQGRSHQWKH
mowing bar.
5HPRYHWKHH[SDQVLRQSLQ%)LJDQGVOLGHRXWWKH
toothholding bar (Fig. 69).
,QVHUWWKHQHZWRRWKKROGLQJEDUDQGORFNLWLQSODFHZLWK
the expansion pin.
5HSODFHPHQWRIWRRWKULYHWHG)¿J
:LWKWKHLPSOHPHQWUHVWLQJRQWKHJURXQGRSHQWKH
mowing bar.
5HPRYHWKHH[SDQVLRQSLQ%)LJDQGVOLGHRXWWKH
toothholding bar (Fig. 69).
5HPRYHWKHGDPDJHGWRRWKXVLQJDSLQSXQFK
5LYHWDQHZWRRWKZLWKWKHULYHWVSURYLGHG))LJ
,QVHUWWKHWRRWKKROGLQJEDUDQGORFNLWLQSODFHZLWKWKH
expansion pin.
ATTENTION
It is absolutely essential to disengage the
tractor pto, lower the mowing machine, switch
off the tractor, ensure that this is at a com-
plete standstill and remove the key before
servicing, adjusting the implement for work.
All assembly operations must be carried out
on a work bench.
Replacement of bar holding removable tooth
:LWKWKHLPSOHPHQWUHVWLQJRQWKHJURXQGUDLVHWKH
mowing bar and secure it with the hooking tie rod.
8QVFUHZDOOWKHWRRWKIDVWHQLQJVFUHZV)LJ
5HPRYHDOOWKHWHHWK)LJ
5HPRYHWKHH[SDQVLRQSLQDQGVOLGHRXWWKHEDU
,QVHUWWKHQHZWRRWKKROGLQJEDUDQGORFNLWLQSODFHZLWK
the expansion pin.
5HSRVLWLRQWKHWHHWKE\¿[LQJWKHPZLWKQHZVFUHZVDQG
washers.
Replacement of removable tooth
:LWKWKHLPSOHPHQWUHVWLQJRQWKHJURXQGUDLVHWKH
mowing bar and secure it with the hooking tie rod.
8QVFUHZWKHVFUHZVRIWKHWRRWKWREHUHSODFHG)LJ
3XOORXWWKHWRRWK)LJDQGUHSODFHLWZLWKDQHZ
one, blocking it with new screws and washers. For this
it would be advisable to use a torque wrench, respecting
the values of 30 Nm.
D
E
F
G
Fig. 70
Fig. 71