Maschio FIORE - SERVICE; Extra maintenance; Replacing the cutting blades

SERVICE
38
cod. G19503950
3
([WUDPDLQWHQDQFH
5HSODFHPHQWRIVHFWLRQKROGLQJEDU(¿J
 :LWK WKH LPSOHPHQW UHVWLQJ RQ WKH JURXQG RSHQ WKH
mowing bar.
 5HPRYHWKH H[SDQVLRQSLQ%)LJDQG SXOO RXWWKH
section-holding bar (Fig. 69) with the hooking tie rod (C,
Fig. 69).
 ,QVHUWWKHQHZVHFWLRQKROGLQJEDUDQGORFNLWLQSODFH
with the expansion pin. Lubricate the cutters with very
viscous oil during the assembly phase.
5HSODFHPHQWRIVHFWLRQV'¿J
 :LWK WKH LPSOHPHQW UHVWLQJ RQ WKH JURXQG RSHQ WKH
mowing bar.
 5HPRYHWKHH[SDQVLRQSLQ%)LJDQGVOLGHRXWWKH
section-holding bar (Fig. 69).
 5HPRYHWKHGDPDJHGVHFWLRQXVLQJDSLQSXQFK)LJ
4 on page 6).
 5LYHWDQHZVHFWLRQZLWKWKHULYHWVSURYLGHG')LJ
 ,QVHUWWKHVHFWLRQKROGLQJEDUDQGORFNLWLQSODFHZLWK
the expansion pin.
Fig. 69
B
Fig. 68
C
A
ATTENTION
It is absolutely essential to disengage the trac-
tor pto, lower the mowing machine, switch off
the tractor, ensure that this is at a complete
standstill and remove the key before servicing,
adjusting the implement for work. All assembly
operations must be carried out on a work bench.
During all maintenance operations on moving parts, it is
important to grease all the points indicated in Figure 57
before starting the machine.
Replacing the cutting blades
ATTENTION
7KH H[SDQVLRQ SLQV PXVW EH UHDVVHPEOHG DV
shown in Figure 68 (A), by tightening the screw and
WKHFRQLFDOQXWZLWKDWRUTXHQRWH[FHHGLQJ1P
(YHU\WLPHWKH H[SDQVLRQSLQVDUHGLVDVVHP-
bled and reassembled, one must grease the
blade head concerned (C, Fig. 57).