Maserati MC20 2023 - Page 120

4
118
Instruments and Controls
• user exits full map view.
Navigation Pop-up
During an active navigation the
instrument cluster can show navigation
pop-up.
Navgation pop-up appears in left
contents area and it overlays selected
widget if present (e.g. Compass).
The pop-up is composed by:
• Pictogram (see example in picture)
• Distance to next turn
• Next turn road name
• Lane guidances.
Navi pop-up is not shown when:
• There is no active navigation
• Full map view is active
• Next turn is greater than 300 ft / 100
meters away.
Navigation pop-up is not shown when in
CORSA drive mode.
To clear pop-up press the MENU button
on the left multifunction lever.
Chronometer Management
(CORSA drive mode only)
In CORSA drive mode the only available
content on the left is the “Chronometer”.
To activate the chronometer press
briefly the MENU button on the left
multifunction lever. The information
pop-up message will display on the
instrument cluster left side and then, it
will show the information about the
chronometer.
If the chronometer function is on but no
recording is in progress and the user
holds the MENU button, the function will
be switched off and the instrument
cluster does not show the chrono
content.
The parameters to manage the
chronometer function are the following:
1. Gap from best
2. Current
3. Best
4. Last
5. Chronometer instruction
With the chronometer function on,
by pushing the MENU button, the
chronometer starts to take a lap.
Instrument cluster will show the time
progression and chrono information.
When the chronometer is recording the
lap/time, by pressing the MENU button,
the chronometer takes the lap:
• if the lap is the first, this shall take the
place of the 3 Best and 4 Last;
• if it isn’t the first lap/time but it is better
than 3 Best, it shall be stored in 3 Best
and 4 Last;
• if it isn’t the first lap/time but it is not
better than 3 Best, it shall be stored in 4
Last only.
The area 1 Gap from best shows the gap
time between last and Best times. The
number is green if the time difference
is negative (less time: example shown
in picture: -00:00.354), red if is positive
(longer time: example: +00:00.354).