7
251
Maintenance and Care
• If necessary, refill the filler neck before
screwing the cap.
• Return the cap to its position and wait
for a few minutes to allow the oil to
reach the sump.
• Check the level again.
Engine Oil Filter Replacement
The engine oil filter should be replaced
with a new filter at every oil change.
Contact an Authorized Maserati Dealer
to perform this service.
Dual Clutch Transmission Oil Check
Contact an Authorized Maserati Dealer
for the oil level check.
CAUTION!
The transmission fluid and external
filter should be changed after every 24
hours of track usage. If prompted by
the transmission fluid life monitor that
remaining fluid life is low, the fluid and
external filter should be changed as
soon as possible. Contact an Authorized
Maserati Dealer for these operations.
Fluid Level Check for Transmission
Cooling System
The coolant contained in the reservoir of
this system is equal to the one used for
the cooling system of the engine. For the
preparation of the mixture of water and
antifreeze and for the control of the level,
proceed as shown in the "Engine Coolant
Level Check" of this chapter.
Engine Air Filters Replacement
Contact an Authorized Maserati Dealer
to have the air filters replaced.
A/C Air Filter Replacement
Contact an Authorized Maserati Dealer
to have the A/C air filter replaced.
Wiper Maintenance and Blade
Replacement
Windshield Wiper Maintenance
Life expectancy of wiper blades varies
depending on the geographical area’s
weather conditions where the car
is used and frequency of use. Poor
performance of blades may be present
with chattering, marks, water lines or
wet spots. If any of these conditions
are present, clean the wiper blades or
replace if necessary.
Clean the rubber edges of the wiper
blades and the windshield periodically
with a sponge or soft cloth and a mild
nonabrasive cleaner. This will remove
accumulations of salt or road film.
Operation of the wipers on dry glass for
long periods may cause deterioration of
the wiper blades.
Always use washer fluid when using the
wipers to remove salt or dirt from a dry
windshield.
Avoid using the wiper blades to remove
frost or ice from the windshield. Keep
the blade rubber out of contact with
petroleum products such as engine oil,
gasoline, etc.
Spray nozzles
If the jet does not work, first check that
there is fluid in the pan (see paragraph
"Level checks" in this section) then check
that the nozzles are not clogged.
Blades Replacement
• Lift the wiper arm.
• Press the indicated button, slip off the
blade support from the arm and replace
it.
To Next Page
Loading...
