4
140
Instruments and Controls
is less than 7.5 MPH (12 km/h). The
system can be enabled with “Sound
Only", "Sound+Display", or turned “Off”.
See "Park Assist" in section "Starting
and Driving" for further information.
• ParkSense Front Sensors Active in
Drive
If this function is active, when driver
moves from P (Park) or N (Neutral) to D
(Drive) mode, front parking sensors are
activated. If this function is not active,
when driver moves from P (Park) or
N (Neutral) to D (Drive), front parking
sensors are NOT activated.
•
ParkSense Volume
When this function is selected, the
chime volume of front and rear park
assist sensors can be set to "Low",
"Medium" or "High" level. “Medium”
is the default setting. The system will
retain its last known configuration state
through ignition cycles.
• Blind Spot Alert
Activating this function the system
will try to prevent collision between
host vehicle and potential blind spot
collision hazard.
This function can be set in “Off”,
“Lights” or “Lights + Chime”.
See Blind Spot Assist - BSA” in section
“Starting and Driving” for more details.
• Forward Collision Warning
The FCW function primary use the
forward looking camera for sensing
vehicle, pedestrian and cyclist ahead,
provide warnings to the driver and may
perform brakings and brake jerks (if
set).
The FCW system setting chosen by the
User is kept in memory at every key-
off. At the next key-on, if the function
is in the not available (OFF) status,
the relative telltale is displayed on the
instrument cluster.
It is possible to set the warnings, the
sensitivity and the aid of the active
braking.
FCW warnings can be set in "Off",
"Only Active Braking" (default mode)
and "Warning + Active". FCW
sensitivity can be set to “Near”, to “Med
(Medium)” or to “Far”.
FCW with active braking can be set to
“On” or “Off”.
See "Forward Collision Warning - FCW"
in section "Driver Assistance Systems"
for more details.
• Side Distance Warning
When this function is selected, the
surround screen visualize 4 more arcs
on the vehicle sides in the top view.
• Traffic Sign Assist
Activating this function the forward-
facing digital camera, with the aid of
maps on the navigation system, is able
to detect signs (no overtaking, etc.)
and speed limits. Those are displayed
by the TSA system on the instrument
cluster display together with a possible
alert when the vehicle exceeds the
speed limit.
See “Traffic Sign Assist - TSA” in
section “Driver Assistance Systems” for
further details.
Clock & Date
Time is always visible in digital format
on the instrument cluster and on the MIA
display.
With this function it is possible to view
and set the following modes.
• Sync Time with GPS
Time is normally automatically
synchronized with the radio signal.
It is also possible to set automatic
synchronization mode using GPS signal
instead.
• Set Time Hours
With "Sync Time with GPS" function
unchecked and this mode selected, you
can set the hours manually from 0 to
23. To select, touch the "+" or "–" soft-
keys to adjust the hours.
• Set Time Minutes
With "Sync with GPS Time" function
unchecked and this mode selected, you
can set the minutes manually from 0 to
To Next Page
Loading...
