Maserati MC20 2023 - System with Devices Without Rolling Code; Canadian;Gate Operator Programming

2
66
Understanding the Vehicle
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
HomeLink
®
buttons, repeat each step
for each remaining button. DO NOT
erase the channels.
Reprogramming a Single HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the ON
position without starting the engine.
• Press and hold the desired HomeLink
®
button.
• Without releasing the button proceed
with “Programming the hand-held
transmitters” from second step and
follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before 1995
• Turn the ignition device to the ON
position without starting the engine.
• Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink
®
button you wish to program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
NOTE:
The distance necessary between the
portable hand-held transmitter and the
HomeLink
®
in the vehicle depends on the
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
• Press and hold the programmed
HomeLink
®
button.
If the garage door opener/device
activates, programming is complete. To
program the remaining two HomeLink
®
buttons, repeat each step for each
remaining button. Do not erase the
channels.
Reprogramming a Single HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the ON
position without starting the engine.
• Press and hold the desired HomeLink
®
button.
• Without releasing the button proceed
with “Programming the hand-held
transmitters” from second step and
follow all remaining steps.
Canadian/Gate Operator
Programming
The programming of transmitters in
Canada/United States require the
transmitter signals to “time-out” after
several seconds of transmission:
NOTE:
Canadian Radio Frequency (RF) laws
require transmitter signals to time-out
(or quit) after several seconds of
transmission, which may not be long
enough for HomeLink
®
to pick up the
signal during programming. Similar to
this Canadian law, some U.S. gate
operators are designed to time-out in
the same manner.
It may be helpful to unplug the device
during the cycling process to prevent
possible overheating of the garage door
or gate motor.
1 Place the ignition in the ON
position.
2 Place the hand-held transmitter 1
to 3 inches (3 to 8 cm) away from