Maserati MC20 2023 - Controls to Set and Configure the Instrument Cluster

4
110
Instruments and Controls
Controls to Set and
Configure the Instrument
Cluster
The basic configuration of the instrument
cluster depends on the driving mode set
on the selector of the central tunnel (see
“Drive Mode” in section “Starting and
Driving”).
The user can then interact with the
instrument cluster by moving some areas
of the central sector, switch between
the parameters that can be displayed
in the customizable areas and other
functions.
These operations can be performed
through the buttons located at the end
of the multifunction levers behind the
steering wheel.
MENU Button on Left
Multifunction Lever
This button allows you to navigate inside
the different environments of the left
side of the screen.
The transition from one screen to
the other is done when the button is
released.
When the instrument cluster displays
the Trip screen, the long press of this
button performs the reset of some of the
displayed Trip values (see “Instrument
Cluster Contents” in this section).
When the instrument cluster displays the
navigation information/Compass, the
long press of this button manages the
map visualization.
When in CORSA drive mode, this button
becomes the chrono control (see “Drive
Mode” in section “Starting and Driving).
VIEW Button on Right
multifunction Lever
This button allows you to navigate inside
the different environments of the right
side of the screen.
The transition from one screen to
the other is done when the button is
released.
This button can be used to dismiss
a system message (see “Instrument
Cluster Contents” in this section).
Screens Transition
On the left and right areas of the central
sector shown in picture you can view
different environments plus an empty
configuration. The switching between
these screens is performed acting on the
MENU and VIEW buttons located at the
end of the multifunction levers.
At key-on, the display must show the
last content configuration present at the
previous key-off.