4
112
Instruments and Controls
Instrument Cluster
Contents
Visualization at Key On and Key
Off
When doors are opened, the instrument
cluster displays the odometer plus the
open doors indicator in the lower part
of the instrument cluster.
When the driver's door is closed, a start-
up animation is displayed and then the
image of the car with the transmission
status, while the odometer is visible.
The message prompting you to press
the ignition device to start driving is then
displayed (see picture).
At this point of the start-up procedure, if
the car needs to carry out the scheduled
maintenance service, the relative
message will be displayed with the
indication of the km/mi that are missing.
Once the key on or the cranking has
been performed, the instrument cluster
displays the default screen configuration
corresponding to GT drive mode. In case
the full map view was visualized at the
last key off, then GT with map shall be
visualized.
When the key off is performed, if at
least one of the doors is closed, the
instrument cluster shows the image of
the car.
Display of Warning and Indicator
Lights
Warnings and Indicator Lights have
different positions on the instrument
cluster display:
Hard telltales have fixed positions in the
side sections of the instrument cluster.
United States Market
Canadian Market
Soft telltales are fitted in the central
section of the instrument cluster; some
of them are displayed in the same
area according to the meaning of the
symbols. The only exception is the
EPS fail warning light which has priority
over the suspension indicator lights
which may be displayed in the same
position.
On the right lower side of the screen
indicated in picture, there is a “rolling”
area where the remaining amber and red
soft telltales can be displayed.
To Next Page
Loading...
