5
200
Starting and Driving
Speed
MPH
(km/h)
Maximum 130 (210)
Setting Desired Speed
Turn on the CC function. When the
vehicle has reached the desired
speed (in the example: 60 MPH), push
downward the multifunction switch (SET
-) and release.
The green light with below the
desired speed will illuminate on the
cluster display.
Release the accelerator and the vehicle
will operate at the selected speed.
NOTE:
The vehicle should be travelling at a
steady speed and on level ground before
pushing the switch downward.
Pressing the "CANC" button or
moving the ignition device in STOP
position erases the set speed memory.
Changing Speed Setting
Pushing the multifunction switch upward
(RES +) or downward (SET -) once, or by
holding it down, will enable to increase
or decrease the set speed by one unit (1
MPH or 1 km/h).
If the car is equipped with ADAS
Systems, the single press of the
multifunction switch will increase or
decrease the set speed of 1 MPH or 1
km/h; a continuous pressure of the same
will increase or decrease the set speed
of 5 MPH or 10 km/h.
Release the switch when the desired
speed is reached, and the new set speed
will be visualized below the green light.
Each subsequent tap of the multifunction
switch will increase or decrease the
speed by 1 MPH or 1 km/h.
Temporary Deactivation
A soft tap on the brake pedal, pressing
the CANC button, or normal brake
pressure while slowing the vehicle will
temporarily deactivate the CC without
erasing the set speed memory. The
white light with below the set speed will
appear on the cluster display.
Driver Override
If the driver presses the accelerator
pedal while the CC is on, such as to
overtake another vehicle, and exceeds
the set speed limit, the system will
temporarily deactivate the CC.
When the accelerator pedal is released,
the vehicle will return to the set speed.
Resume Speed
To resume a previously set speed, push
upward the multifunction switch (RES
+) and release. The green light with
below the set speed will illuminate on
the cluster display. Resume can be used
at any speed above 18 MPH (30 km/h).
Using Cruise Control on Hillsides
The transmission may be downshifted
on hills to maintain the vehicle set speed.
The CC system maintains set speed up
and down hills. A slight speed change
on moderate hills is normal. On steep
To Next Page
Loading...
