5
195
Starting and Driving
When pressing the D/M (Drive/Manual)
button or both paddles, the rear camera
mode is exited and the navigation or
audio screen appears again.
When displayed, dynamic grid lines (if
the function is set to MIA through the
"Settings" menu of the "Vehicle" page)
will illustrate the width of the vehicle
to assist with parking or aligning to a
hitch/receiver. The dynamic grid lines
will show separate zones in different
color that will help indicate the distance
to the rear of the vehicle.
The following table shows the
approximate distances for each zone
and color:
Zone
Distance to the rear of the
vehicle
Red 0 - 16 in (0 - 40 cm)
Yellow 16 - 39 in (40 cm - 1 m)
Green 39 - 118 in (1 - 3 m)
WARNING!
Drivers must be careful when reversing
even when using the rear view camera.
Always check carefully behind your
vehicle, and be sure to check for
pedestrians, animals, other vehicles,
obstructions, or blind spots before
reversing. You are responsible for the
safety of your surroundings and must
continue to be careful while reversing.
Failure to do so can result in serious
injury or death.
CAUTION!
•
To avoid vehicle damage, the rear
camera should only be used as a
parking aid, as the rear camera is
unable to view every obstacle or object
in your drive path.
•
To avoid vehicle damage, the vehicle
must be driven slowly when using
the rear camera to be able to stop in
time when an obstacle is seen. It is
recommended that the driver looks
frequently over his/her shoulder when
using the rear camera.
NOTE:
If snow, ice, mud, or any other
substance builds up on the camera lens,
clean the lens, rinse with water, and dry
with a soft cloth. Do not cover the lens.
To Next Page
Loading...
