42 Radical Signal Extraction Pulse Oximeter Operator’s Manual
4
home mode operation
The Radical can be placed into the Home Mode to protect unqualified users from changing
the Radical alarm settings and operation. Entering a password does not automatically reset
the Radical to the Normal operating mode. In the Home Mode, a password is required to
access the menu system and the touch key control buttons and icons.
NOTE: When the Radical is set to operate in the Home mode the default values that the
Radical reverts to after a power cycle are set according to Section 3, Monitor Setup, with
the exception of the Alarm Silence setting, which is set to the pre-power down setting.
password operation
The Radical password is 2-3-1. To enter the password use the touch-key control buttons to
the right or bottom of the LCD display and press the buttons in the sequence shown in the
following figure:
To return to normal operating mode set the General/Home Use parameters to
“
No
”
.
operation
First press
➙
✘
Then press
➙
Finally press
➙
3
2
1
3
2
1
3
2
1
✘ ✘
To Next Page
Loading...
