Matrix Vision User Manual

Matrix
134
Vision System Manual
Any external device meeting above specifications can be connected with the system. The volume must be set
to a level such that the music is not very low or very loud. The volume of the signal coming from this device
must never increase beyond the specified limits.
The external music port is an audio input port and no electrical signal of higher value than the specified
limit should be applied to this port. This may result in permanent damage to the system. Matrix warranty
does not cover damages resulting from improper use.
VM Music
A music of your choice can be recorded in the Voice Module and the same can be played while keeping a trunk/
station on hold.
How to program?
Use following command to select music source:
1102-Code
Where,
Code Meaning
0 Internal Music
1 External Music
2
VM Music *
* This command will be assigned only after programming VM for music on hold application.
Important Points:
• On inserting the audio signal jack of the external music source, the internal hold on music stops and the hold
party gets external music. The hold party can be trunk or a station.
• To know programming details, please refer “Configuration Reports”.
Relevant Topic:
1. Voice Message Applications 205
=X=X=

Matrix Vision Specifications

General

Brand	Matrix
Model	Vision
Category	PBX
Language	English