Matrix Vision User Manual

Matrix
58
Vision System Manual
Call Progress Tones
The Vision gives various tones in different situations. This is how the Vision responds to dialing of codes and
commands.
Dial Tone
When you lift the handset you get dial tone. Dial tone stays for 7 seconds. This Dial Tone Timer is
programmable. After that error tone starts.
• Sound: Toooooooooooo
Use following command to program the Dial Tone Timer:
3001-Seconds
Range = 001 to 255 seconds.
Default = 007 seconds.
Ring Back Tone
When you dial internal number and if that number is free, you will get the ring back tone. The ring back tone
continues for 45 seconds. This Ring Back Tone Timer is programmable.
• Sound: Turroo... Turrroo
Use following command to program the Ring Back Tone Timer:
3002-Seconds
Range = 001 to 255 seconds.
Default = 045 seconds.
Busy Tone (Engage Tone)
High pitch beeps with equal on and off periods. When you dial any station that is busy, you get busy tone. Busy
tone continues for 7 seconds. This timer is programmable.
• Sound: Tooooooo.........Toooooooo
Use following command to program the Busy Tone timer:
3003-Seconds
Range = 001 to 255 seconds.
Default = 007 seconds.
Error Tone
The Error Tone is made of fast beeps. When you perform some wrong operation or try using a feature without
access, you get error tone.
• Sound: Too…Too…Too…Too
Use following command to program the Error Tone timer:
3004-Seconds
Range = 001 to 255 seconds.
Default = 030 seconds.
Internal Call Waiting Tone
Short beep followed by longer off duration repeated every second. This is also known as intrusion tone. Busy
user gets this tone over his speech when some other station attempts interrupt request/barge-in.
• Sound: Beep.…………Beep
The user gets this tone till the Interrupt request timer or the barge in timer.

Matrix Vision Specifications

General

Brand	Matrix
Model	Vision
Category	PBX
Language	English