Matrix
154
Vision System Manual
Remote Programming
What’s this?
One can program Vision from any remote location. The remote user can program the system using the same
commands as used by a normal local station to program the system.
How it works?
Following flow chart depicts the process:
Start
Call the system from the remote end
Operator dials the command
Is SE/SA
password
correct ?
System gives Error tone
to the operator
System gives programming tone
The person at remote end/operator
can dial any programming command
Is the command
dialed correct and
accepted by the system/or
'00' dialed ?
System gives dial tone
End
Confirmation Tone
Error Tone
Yes
No
sk the operator at the system end to hold you
and dial 1#91-SE Password or 1#92-SA Password
Operator should dial Flash
Operator and remote end
comes in speech
'00'
dialed
No
Yes
To Next Page
Loading...
