Matrix Vision User Manual

Vision System Manual
97
Matrix
How to program?
Step 1: Enable/Disable DID on trunk/s during daytime using command 3501.
Step 2: Enable/Disable DID on trunk/s during nighttime using command 3502.
Step 3: Enable/Disable Voice Guidance for DID on trunk/s during daytime using command 3503.
Step 4: Enable/Disable Voice Guidance for DID on trunk/s during nighttime using command 3504.
Step 5: Program the DID timers using command 3022-3028.
Step 6: Record DID voice message. (if required).
Step 1
Use following command to activate DID on a trunk during day time:
3501-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.
Code Meaning
0 DID deactivated
1 DID activated
Use following command to activate DID on all trunks during day time:
3501-*-Code
Step 2
Use following command to activate DID on a trunk during night time:
3502-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.
Code Meaning
0 DID deactivated
1 DID activated
Use following command to activate DID on all trunks during night time:
3502-*-Code
By default, DID is OFF on all trunks during day time and night time.
Step 3
Use following command to activate Voice Guidance for DID on a trunk during day time:
3503-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.
Code Meaning
0 Voice Guidance for DID deactivated.
1 Voice Guidance for DID activated.
Use following command to activate Voice Guidance for DID on all trunks during day time:
3503-*-Code
Step 4
Use following command to activate Voice Guidance for DID on a trunk during night time:
3504-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.

Matrix Vision Specifications

General

Brand	Matrix
Model	Vision
Category	PBX
Language	English