Mauldin 1860 - Maintenance and Service; Fire or Explosion Prevention; Safety Decals

7
Calder Brothers Corp
V 1.0
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
Model: 1860 Paver
^ WARNING
Improper operation, lubrication or maintenance of this paver can be dangerous and could result
in injury or death.
^ WARNING
Do not perform any lubrication and maintenance on this paver until you read and understand
the instructions in the maintenance section of this manual.
2.3.1 ^ Maintenance And Service
Before performing inspections, service or maintenance:
• Park paver on rm level surface.
• Lower screed to ground or engage screed support locks.
• Fully open or close hoppers.
• Turn engine off and remove ignition key.
• Attach a Do Not Operate tag or similar warning tag to the ignition switch.
• Follow lockout/tag out procedure as dened by your company.
After performing inspections, service or maintenance, verify all guards have been installed and all safety devices
are functional.
Always wear face or eye protection, safety shoes, and other protective items as required by your company.
If you must troubleshoot machine with engine running, have someone in constant visual contact who can shut
off the engine or engage an Emergency Stop.
If you must service machine with an attachment raised, block up that attachment in a safe position.
2.3.2 ^ Fire Or Explosion Prevention
^
Engine fuel can cause an explosion or re. Do not service fuel system with engine running or near open re.
Do not weld or smoke near fuel system. Do not spill fuel or hydraulic oil on hot machine components. Clean up
spilled fuel or oils immediately.
^Keep sparks and ames away from batteries to prevent explosion of hydrogen gas in and near a battery.
Other precautions include:
• When disconnecting battery cables, disconnect negative (-) cable rst.
• When connecting battery cables, connect negative (-) cable last.
• Do not short circuit battery posts with metal items.
2.4 Safety Decals
Safety decals are located on the paver to identify operational and maintenance hazards. The safety decals are
placed according to the hazard in that area of the paver. Read and understand each of the safety decals and the
hazard it references. These safety messages are additional information to the safety content described in this
operator’s manual.
All safety decals must be legible at all times. Avoid using harsh chemicals or pressure washing. If the safety decal
is no longer legible, replace it with a new one. Contact your dealer for new decals.