Mauldin 1860 - Change Engine Oil and Oil Filter; Monthly; Every 250 Hours; Inspect Conveyor and Drive System

38
Calder Brothers Corp
V 1.0
Model: 1860 Paver
SN:
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
6.5.2 Change Engine Oil And Oil Filter
1. See OEM engine operators manual for oil and lter
specication.
2. Fully open hopper doors.
3. Prepare paver for inspections and maintenance. See
Section 6.2 Prepare For Inspections And Maintenance.
4. Wear personal protective equipment appropriate for the
task.
5. Allow engine and surrounding parts to cool before
proceeding.
6. Position an adequate drain pan under plug (1).
7. Remove plug (1) to drain engine oil. Install plug after all
oil has drained.
8. Remove cover (2) to access engine oil lters.
9. Remove and discard existing oil lter.
10. Fill new lter with clean engine oil.
11. Lightly coat lter sealing ring with oil.
12. Install lter until seals contacts ange. Tighten an additional 1/2 - 3/4 turn by hand. Do not over tighten.
13. Fill crankcase to correct level.
14. Start engine and run at low idle.
15. Stop engine and check for leaks.
16. Check engine oil level.
17. Install cover (2).
18. Dispose of oil and lter in an environmentally safe manner.
6.6 Monthly / Every 250 Hours
6.6.1 Inspect Conveyor And Drive System
1. Prepare paver for inspections and maintenance. See
Section 6.2 Prepare For Inspections And Maintenance.
2. Wear personal protective equipment appropriate for the
task.
3. Check for worn sprockets and chain.
4. Check keys and keyways for wear. Replace keys if
needed.
5. Tighten conveyor chains with slack adjusters (1)
mounted to the underside of the conveyor. Tighten
until the chains pull up to within 8 in. (203 mm) of the
underside of the conveyor deck. Measurement should
be made from the peak of the arc in the chains. Do not
over tighten.